- 25 -
Z5
DT
User’s Guide
Appendix 4.2 parallel interface
Parallel interface works under IEEE1284 compatible mode.
Pin
Definition Description
Pin
Definition
Description
1
Input
/STROBE
13
Output
SELECT
2
Input
Data0
14
Input
/AutoFd
3
Input
Data1
15
Not defined
NC
4
Input
Data2
16
-
Logic
Ground
5
Input
Data3
17
-
Chassis Ground
6
Input
Data4
18
-
Vcc
7
Input
Data5
19 ~ 30
-
Signal Ground
8
Input
Data6
31
Input
/Init
9
Input
Data7
32
Output
/Fault
10
Output
/ACK
33
-
Ground
11
Output
BUSY
34 ~ 35 Not defined
/NC
12
Output
PError
36
Input
/SelectIn
Table appendix 4.2-1 parallel signal list
Caution:
In the process of data transmission, the host computer should not ignore the Busy signal; otherwise the
print data may be lost;
Parallel interface signal adopts TTL level. Ensure the rise and fall time of host computer is not longer than
0.5
s when it is used.
Appendix 4.3 USB interface
USB interface meets USB1.1 protocol standard and is optional.
USB interface transmits signal and power via a four
–wire cable, as shown in the following figure:
Figure appendix 4.3-1 USB cable
Wire D+ and D- in figure appendix 4.3.1 are used for signal transmission, and the VBUS is +5V.
Appendix 4.4 Ethernet interface
Ethernet interface meets the standard communication protocol of 10/100M BASE-T in IEEE802.3 and is
optional.
PIN
Signal name
Signal direction
Function
P1
TX+
Difference data signal
P2
TX-
Output -
Difference data signal output-
P3
RX+
Input +
Difference data signal input+
P4
Reserve
——
——