AMS TOUCHLESS, Руководство по эксплуатации и обслуживанию

Страница: 25 / 50

L0192A
19
Figure 5.2 Large Bag Vending
Figure 5.3 Candy Pusher Bar Installation
HELIX HOME POSITION
Unless you are using the “Sensit Only” Motor Type, after a motor
has been configured check to make sure all the helices are in
the home position. The ‘CONFIGURE’ command (in the Tray
Setup menu) will leave the motors in their home position. Look at
each helix to see If the end of the helix is positioned as shown in
Figure 5.1
below- if it is not in the recommended position, pull it
out of the motor, turn it until it is, and reinsert the helix into its
motor.
AVOIDING PRODUCT HANG-UPS
Prevent large products, such as chips, from “hanging-up”
between the tray and the glass by loading them “left corner first”
into the helix. The bottom left corner of the bag should be in front
of the helix to let the helix push the bottom out first (See
Figure
5.2
below.) An incorrect loading may cause the bag to fall top
first, which could lead to a hang-up. Loading “left corner first”
prevents the product from falling top first.
TALL PRODUCT VENDING
Place tall, narrow products in a column with a candy pusher bar.
Typically these are installed in columns 10 and 11 on the candy
trays. Rotate the bar upward or downward to the desired
position. It should hold the product upright, but not pinch or bind
the product.
CANDY PUSHER BAR INSTALLATION
The candy pusher bar is an adjustable bar that mounts to any
tray divider to keep tall candies from falling sideways (See
Figure 5.3
below.) Four pusher bars are provided with the
standard glass front vendor.
1. Snap the pusher bar into the retainer.
2. Rotate the pusher bar to accommodate the
product.
5 TRAY ADJUSTMENT AND CONFIGURATION
Figure 5.1 Helix Install Position
Does not apply if using “Sensit Only”
`Motor Type Setting.
A
H
G
F
E
D
C
B
WITH MOTORS AT THEIR
HOME POSITION:
HELIX END POSITION
K-Cup "B"
ALL OTHERS "E"
SCCD
1.5" Dia.
"C"
"D"