6. SENSOR PROGRAMMING
As all ALMEMO
®
instruments contain the whole sensor programming stored in
the ALMEMO
®
connector plug, the user does not usually need to perform any
programming. Only if, for example, sensor errors must be corrected or existing
sensors must be scaled or limit values need to be specified the comprehensive
programming options have to be used. It must be considered that standard
sensors are, by a locking mode, protected against unintentional modification
and that the locking level must first be reduced before desired changes can be
performed (see 6.8). All parameters can easily be entered or changed via
keyboard when the corresponding sensor connector is connected
6.1 Selecting the Input Channel
To query or to program the parameters of a sensor the corresponding input
channel must be selected within the desired function. If this is performed within
any programming function, i.e. not with the rotary switch moved to MEAS.
VALUE, then only the input channel is changed, but not the selected
measuring channel, i.e. the measurement is not interrupted. The selection of a
channel, which is not yet programmed, is only possible in the function RANGE,
if the locking of the 1st channel has been cleared for the corresponding sensor.
Enter input channel directly (e.g. meas. point 12):
,
,
CHANNEL
1
2
Increase input channel successively with the key:
Decrease the input channel with the key:
In case of changes the existing channels only will be considered.
23
ALMEMO
®
5590-2
Sensor Programming
Содержание Almemo 5590-2 V5
Страница 54: ...53 ALMEMO 5590 2 Appendix...
Страница 55: ...ALMEMO 5590 2 54 Notes...
Страница 56: ...55 ALMEMO 5590 2 Notes...