En-2
(1) When remote controller cable exposed
1) Use a tool to cut away the thin area on the upper center of the front
case (indicated by in Fig. 1).
2) Connect the remote controller cable to the remote controller terminal
board specifi ed in Fig. 2.
3) Clamp the remote controller cable sheath with the binder as shown
in Fig. 2.
4) Cut off the excess binder.
5) Install the rear case to the wall, etc., with 2 screws. (Fig. 3)
(2) When remote controller cable embedded
1) Embed the remote controller cable and box.
2) Pass the remote controller cable through the hole in the rear case
and connect the remote controller cable to the remote controller
terminal board specifi ed in Fig. 2.
3) Clamp the remote controller cable sheath with the binder as shown
in Fig. 2.
4) Cut off the excess binder.
5) Install the rear case to the wall, box, etc., with 2 screws. (Fig. 3)
5.2. Setting the DIP switch
SETTING THE DIP SWITCHES
Set the remote controller DIP switches. (Fig. 4)
Fig. 4 [Example]
1
2
3
4
5
6
DIP switch
ON
OFF
NO.
SW state
Detail
OFF
ON
DIP
switch
1
★
Cannot be used.
2
★
Dual remote controller setting
* Refer to 2. Dual remote
control in 6 INSTALLATION
METHODS.
3
★
Cannot be used.
4
★
Cannot be used.
5
★
Cannot be used.
6
★
Cannot be used.
(
★
Factory setting)
5.3. Connection of Remote Controller Cable
CAUTION
• When connecting the remote controller cable (cord) to the wall mounted
type indoor unit, do not connect it to the outdoor unit or the indoor unit
power terminal block. It may cause a failure.
There are 2 methods to connect the remote controller cable to the indoor
unit. One is the connection using contained connecting cable, and the other
is the connection the remote controller cable is connected to the exclusive
terminal block of the indoor unit.
Exclusive terminal block for remote controller connection method is different
depending on each model. Modify the remote controller cable as per below
description and connect it.
•
Display panel
7
8
9
10
11
12
6
1
“
” (Start/Stop Button)
2
“
▼
” , “
▲
” (Set Temperature Button)
3
“ ” (Fan Control Button)
4
“
” (Operation Mode Button)
5
Operation Lamp Display
6
Electric energy Display
7
Standby
Display
8
Operation Lock Display
9
Fan Speed Display
0
Temperature
Display
q
Error
Display
w
Operation Mode Display
5. INSTALLING THE REMOTE CONTROLLER
5.1. Installation
CAUTION
• Do not touch the remote controller PC board and PC board parts
directly with your hands.
Insert the end of a fl at blade screwdriver at the arrow parts of the groove at
the side of the remote controller case and remove the remote controller case
top by turning the screwdriver.
Fig. 1
Fig. 3 [Example]
Fig. 2
Hole
Binder
1. Red
2. White
3. Black
Screws
9371068114-04 EN.indd Sec1:2
9371068114-04 EN.indd Sec1:2
6/27/2557 BE 10:55 AM
6/27/2557 BE 10:55 AM
AMP Air Conditioning
www.ampair.co.uk | [email protected]
