Amity Technology Concord 2250, Руководство по эксплуатации для владельца

Страница: 9 / 49

9
Using the Auger to Load Products
The auger can be used to load and unload seed tanks. It can be
adjusted on brackets to suit the operator's needs.
To place the auger in operating position:
1. Drop the front bracket lock pin just far enough to release the
small pivot arm. (Unpin the long arm only to unload.)
2. Loosen the lock assembly. (Tee Handle)
3. Remove the auger from the rear clamp assembly.
Swing arm, bracket lock pin and small pivot arm
Air cart with auger in loading position
Air cart with auger
Auger
Your Air Cart is equipped with an auger for loading and unloading
the product bins. The auger is mounted on a swing arm that al-
lows a fl exible discharge hose to be moved to each compartment
without moving the hopper. The swing arm also enables the
auger to be turned around to unload and clean out the compart-
ments.
The auger's hydraulic drive is supplied with oil from the blower
hydraulics. A diverter valve above the blower directs oil to the
auger. This may be switched with the blower running.
The auger also has a three position variable speed valve mount-
ed on it to run the auger forward, backward or to stop.
4. Swing the hopper end of the auger away from the Air System
and allow the short pivot arm to come out, away from the
machine.
5. Place the hopper on the ground in a position perpendicular
to the center line of the tanks with the discharge end of the
auger between the compartment lids. From this position
the discharge end of the auger should be able to be moved
between compartments without moving the hopper.
Note
Instuctions are written for a two compartment air cart. Single
compartment air cart use is similar.