Amity Technology Concord 2250, Руководство по эксплуатации для владельца

Страница: 28 / 49

28
Work Switch Operation
The Cart Control System is equipped with manual and automatic
work switches. The manual work switch is a soft key, located on most
screens. The automatic work switch is a sensor, located on the toolbar.
When the system is confi gured for automatic work switch operation,
lifting the machine automatically turns off the meters and NH3 system.
Lowering the machine automatically turns on the meters and NH3 sys-
tem. In this mode you can also use the manual work switch soft key on
the main (Home) screen to turn the meters and NH3 system off. If you
prefer to operate the meters and NH3 system in manual only, you can
confi gure the system to disable the automatic work switch.
Setting Up Work Switch Operation
Selection of manual or automatic work switch is located on the Tool-
bar ECU Main (Home) page. Select the work switch button to
switch between work switch modes.
Green indicates Automatic Work Switch mode
Gray indicates Manual Work Switch mode (Automatic mode off)
Manual Work Switch Operation
The On/Off (Work switch) soft key turns products on or off.
Automatic Work Switch Operation
Note:
The following conditions must be met for the
clutch to engage or for the hydraulic motors to
turn:
-Ground Speed must be above the minimum
speed setting.
-The Work Switch Softkey must be green
-The Seeder Up/Down must show “Seeder
Down”.
Tip!
You can still use the On/Off (Work switch)
soft key on the main (Home) page to turn the
machine off in automatic mode.
Use the following procedure to set up Automatic Work Switch opera-
tion:
Step 1. Raise the seeding system.
Step 2. On the Main (Home) page, press the On/Off (Work switch)
soft key.
Step 3. Start moving forward in the fi eld with the tractor and planting
system.
Step 4. Lower the seeding system. The
Seeder Up/Down display
should indicate Down .
The Seeding State display should turn green.