Amigo Lift-All, Руководство пользователя

Страница: 4 / 24

HeigHt Adjustment
this enables you to raise the pivot tube (#25) from a minimum
height of 12.87 inches (32.68 cm)
to a maximum height of 20.5 inches (52.07 cm). adjust by
placing the anchor clamp (#31) as needed.
boom Angle Adjustment
this provides for adjusting the boom angle from horizontal to 49
degrees by turning the latch hook (#5).
when the angle is set, tighten the nut on the latch hook.
instAllAtion instruCtions
For VeHiCles witH trunks
We recommend you have your Lift•All
®
installed by your local medical
supply dealer or a reputable automotive or body shop.
the objective of the installation is to provide a strong level attachment for
the base plate and positioning which allows adequate clearance for lifting operations and storage.
Please Read All Instructions Before Operating Lift•All
®
loCAting tHe mounting Position
locate a flat metal area at the left rear corner of the trunk. you will need
adequate space on the underside of the trunk floor to accommodate the four
screws to secure the base plate of the lift. (figure 2).
Position the post assembly (#1, figure 2) as close to the rear of the vehicle
as possible (minimum 4 inches/10.16 cm). allow enough room for the boom
assembly to swing out of the rear of the open trunk to a position 90 degrees
relative to the rear bumper. the base plate of the post assembly may be
turned for a better fit and level mounting. trunks with narrow lateral openings
may need extra space between the rear of trunk and mounting bracket.
the post assembly should also be close to the side of the trunk wall
(minimum 6 inches/15.24 cm). allow adequate clearance for the latch
hook (#5, figure 1) as the boom is rotated. this will provide more room for
maneuvering the POV into the trunk.
with the post assembly in the preferred position, the distance from the center of
the post to the opposite trunk opening must be at least 36 inches/91.44 cm, to
accommodate the boom when it is folded for storage.
with the lift in the preferred location, measure the distance from the
mounting plate to the lower lip of the trunk opening. there should be
at least 17 inches/43.18 cm of the vertical distance to insure adequate
clearance between the closed trunk lid and the lift when folded in the
stored position.
Note: Check the location of the support ribs on the underside of the trunk lid to make sure that the stored lift will have
adequate clearance. Be sure the area beneath the floor is clear of pipes, tubing, and electrical wiring. Note the location
of the gasoline tank and STAY CLEAR!
4 www.myamigo.com