Amigo Lift-All, Руководство пользователя

Страница: 6 / 24

suPPort rod Cutting
supplied with your lift is a support rod (#14, figure 6)
consisting of a 7/16-inch (1.11 cm) diameter threaded rod
and a plate at each end. this rod can be cut to provide a side
support and a front support rod. the rod should not extend
past the screw mounting the l-bracket.
first, measure from the center of the post assembly (#1, figure 2)
to the face of the l-bracket (#10, figure 5) on the trunk side drip
ledge. next, measure the same distance from the center of the
hole in one end of the support rod, add 5/8-inch(1.59 cm) and
mark. cut threaded rod at place marked and remove any burrs
with a flat file. thread a nut over the rod end, about 1-1/2 inches
(3.81 cm) from the end.
to make the front support rod, repeat the above procedure,
measuring the l-bracket on the trunk front drip ledge.
suPPort rod instAllAtion
remove the shoulder screw and the top washer from the
pivot tube assembly (#25, figure 1). insert the side and
front support rods through the holes in the appropriate
l-brackets (#10, figure 5).
line up the holes in the ends of the support rods with
the center hole in the pivot tube assembly (#25, figure
1). then reinstall washer and shoulder screw and tighten.
install a second nut on the end of each support rod (#14)
and tighten both jam nuts until each rod is securely
fastened to the bracket.
supplied with the lift is a plastic piece of wire loom 36 inches (91.44 cm) long.
this can be measured and cut to fit over the two rods to protect other objects in the trunk.
instAlling tHe boom Hold-down
Before drilling any holes through the floor in the
rear of the vehicle, note the position of the gas tank
and STAY CLEAR!
Drill a 11/32-inch (8.7 mm) diameter hole in the floor
directly under the spool when the boom is folded down
for storage, parallel to the rear door (see figure 8).
install the supplied eye bolt through the above hole.
thread a nut on the eye bolt on the underside
of the floor and tighten securely.
now, lower the boom assembly into the storage position
and adjust the shock cord hook to the proper length to hold the boom down. to adjust the length of the shock
cord, loosen the knot on the hook end of the cord and move it away from the end of the cord until the appropriate
length is reached. tighten the knot securely and firmly place the hook over the knot. remove any excess shock
cord.
6 www.myamigo.com