Amigo Lift-All, Руководство пользователя

Страница: 5 / 24

when all clearances are satisfactory, mark the position of all four mounting holes in the post mounting plate on
the floor of the trunk.
Mounting the Lift•ALL
®
in PAssenger VeHiCles
Drill four 3/16-inch (4.8 mm) diameter holes through the trunk floor as previously marked (figure 3).
Before drilling any holes through the trunk floor,
note the location of the gasoline tank and STAY CLEAR!
screw the post plate to the floor using the self-tapping
screws supplied. check the post to make sure it is vertical
and does not lean to one side. shim under the base plate if
necessary, with washers, and tighten all screws securely.
instAlling uPPer suPPort brACkets
And rods
the post assembly must be braced at the top to prevent
flexing when picking up a POV with the boom. two support
rods (#14) must be connected to the front and side of
trunk lip, as shown on figure 4, or to other suitable support
areas. l-brackets (#10) are used to make these necessary
connections (see bracket installation).
HeigHt Adjustment
adjust the height of the outer tube pivot assembly (figure #1)
to provide proper boom rotation and clearance. loosen the
anchor clamp (#31) and slide the outer tube pivot assembly to the
required height (approximately the same height as the left side lip
of the trunk opening).
lightly tighten the screw in the anchor clamp (#31) so that
it fits tightly against the post.
brACket instAllAtion
using a straightedge, mark the position of the hole to be
drilled in the side trunk lip for installation of an l-bracket.
repeat for installation of the front trunk l-bracket.
Drill two 1/4-inch (.635 cm) diameter holes through the
trunk drip ledge in the positions marked (figure 4). loosely
install an l-bracket (#10) at each location using a screw
(#8), washer (#11), and a locking nut (#9, figure 5).
www.myamigo.com 5