Amigo Lift-All, Руководство пользователя

Страница: 7 / 24

NOTE: The shock cord must be adjusted to the proper length to keep the
boom assembly from moving freely to avoid damaging the Lift•All
®
or the trunk lid.
instAllAtion instruCtions
For VAns, truCks
And suVs
installation of Lift•All
®
in vans and suVs or other vehicles
where adequate structure for support rods (figure 6) is
not available may require support bracket.
loCAting tHe mounting Position
locate a flat metal area of the vehicle floor in the rear corner.
Position the support bracket 6” (15 cm) min. as close to the rear
door and inside wall as possible without interfering with the
door operation. use the left hand support bracket for left rear
corner mounting and the right hand support bracket for right
hand corner mounting. allow a minimum of three inches (7.6
cm) of space between inside base panel of the vehicle’s door
or tailgate and the round post of the support bracket. select
and mark one hole in each of the three mounting positions.
check the underside of the vehicle to be sure that the holes are
accessible and will not interfere with any structural members.
NOTE: For maximum support, try to use the mounting holes closest to the end of the tube.
Mounting the Lift•ALL
®
in VAns,
truCks, And suVs
Before drilling any holes through the floor of the trunk,
note the position of the gas tank and STAY CLEAR!
Note: Refer to figure 3 on page 5. Also note fold down seats and storage compartments.
Drill three 1/4-inch (6.4 mm) diameter holes through the floor of vehicle as previously marked. Place a screw through
the cone washer and the proper hole in the support bracket and floorboard. One large flat washer should be placed
over the screw below the floor. install and tighten the hex nut securely. repeat the procedure with the other two
mounting screws.
install the pivot tube assembly over the round tube on the support bracket. set the coupling of the
connector over the square tube of the support and install screw and nut.
Tighten fasteners securely so that there is no play between support bracket and the Lift•All
®
assembly.
VAn brACket VertiCAl HeigHt Adjustment
adjust height by removing the 5/16” screw #5567 (see exploded diagrams and parts list) and raising the connector
weldment #5660 to the desired height; replace and tighten the screw. the screw #5567 should be completely inserted
through the hole in the connector weldment and the van bracket upright tube.
www.myamigo.com 7