AMI Entertainment Rock-Star Lx, Инструкция по установке и эксплуатации

Страница: 45 / 52

Page 43
LED Indicators
The LEDs are described below and can help you isolate a problem. For Rock-Ola’s Digital SyberSonic
Pre-Amp LED indicators, see page 22.
ROWELINK CONTROLLER
5 VDC, 12 VDC, 24 VDC, and 24 VAC LED’s
Should be on. On when there is power to the ROWELINK CONTROLLER.
IR RCV LED
Flashes whenever any IR signal is seen by the IR RECEIVER. May flash due to ambient light.
KID RL TX LED
Should be flashing **. Flashes when the ROWELINK CONTROLLER sends an RL signal back to
CORE COMPUTER. Rate is approximately ten times per second.
CC RL RX LED
Should be flashing**. Flashes when ROWELINK CONTROLLER receives a RL signal from one of
the RS-485 bus devices. Appears almost continuously on (rate is more than 20 times per second).
CC RL TX LED
Should be flashing **. Flashes when Rowelink Master Commands are sent from the Computer
Core. Appears almost continuously on (rate is more than 20 times per second).
CRDT RL TX LED
Should be flashing **. Flashes when the ROWELINK CONTROLLER sends a RL signal back to
the CORE COMPUTER. Rate is approximately once per second.
CRDT STATUS LED
Will flash when a coin is inserted and the CRDT RL TX LED is flashing. May or may not flash when
a coin is inserted if the CRDT RL TX LED is not flashing.
** When the COMPUTER CORE ASSEMBLY is powered up, then it may take several minutes for
the LED’s to start flashing.
COMPUTER CORE ASSEMBLY
+5 V LED (GREEN)
This should be lit whenever the jukebox is connected to 120 VAC service.
HDD LED (RED)
This LED should be lit only when the hard drive is being accessed by the computer.
POWER SUPPLY ASSEMBLY
+12 VDC (RED)