AMI Entertainment Rock-Star Lx, Инструкция по установке и эксплуатации

Страница: 12 / 52

Page 10
IR Remote Installation Instructions
The Rock-Star Lx comes with an IR remote (located
in the Handy Pack). To install, plug the provided
cable into the provided IR remote receiver (see
Figure 8-B ) and route the other end of the cable
through one of the wire access holes in the upper left
corner of the cabinet. Connect the end of the cable
into the port labeled “P11 IR Detector” on the
Rowelink Controller. Install the IR remote receiver
above the jukebox, with a clear line of sight between
the receiver and the handheld transmitter. Plug in
and turn on the jukebox and test the remote (after
installing the hard drive).
Figure 8-B – IR Remote Receiver
Button Functionality on the IR Remote
Transmitter
To enable or disable options on the IR remote, see
“IR Remote Setup” in the
Network Setup, Jukebox
Operation, Operator Setup Screens Manual.
The
REJECT button is used to cancel (or “Reject”)
the selection currently playing and cancels all
(Rejects all) selections in the queue if held down for 4
seconds. This functionality can be enabled/disabled
through the software.
The POWER button turns the lights, the LCD display,
the bill acceptor(s), and the credit card reader
ON/OFF. To turn them back on and resume normal
operation, press the “POWER” button again.
VOLUME
The CH1+ and CH2+ buttons raise the volume.
The CH1– and CH2– buttons lower the volume.
The PLAY button puts the jukebox in play mode.
The
PAUSE button puts the jukebox in pause mode
for a programmed amount of minutes or until the
PLAY button is pushed.
The
AP OFF and AP ON buttons turn any
programmed Autoplay mode on/off.
The
FUTURE button is used to give a remote credit.
The
VID SEL button is reserved for future use.
RECEIVER SHOULD
BE INSTALLED WITH
SENSORS FACING FRONT
CABLE CONNECTED TO
TOP OF RECEIVER