23
Q. Install electrical system
Connect the power source on the data plate of power unit.
Note: 1. For the safety of operators, the power wiring must contact the floor well.
2. Pay attention to the direction of rotations when using three phase motors.
Single phase motor (See Fig. 34).
1.
Connecting the two power supply lines (
Active
L
and
Neutral
wire
N
) to terminals of AC
contactor marked
6#, 2#
respectively.
2.
Connecting the power supply earth wire to
G
on the motor.
3.
Connecting the Limit Switch: Removing the wire of connecting terminal
4#
on
control button and terminal
1#
on AC contactor firstly
(See Fig. 35)
, then
connecting wire
10#
of the limit switch with terminal
4#
of the control button and
connecting wire
9#
with terminal
A1
on AC contactor respectively
(See Fig. 36)
.
Motor Connecting Diagram
Fig. 34
9#
Remove this wire
before connecting
the Limit Switch
10#
Fig. 35
Fig. 36
Содержание HS-12
