70 mm
64 -0,3 mm
Y
X
X
S-311
1-48
Released:01/2014
E-mail: [email protected]; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
8. ADJUSTMENT OF THE CUTTING MECHANISM
Caution:
Before doing the adjustment, it is necessary that the parameters, especially the cutting space and correction
was adjusted on 0 - section D9, buttons
The cut position is given by the point of departure of the stepping motors adjustment. The sensor plates screws are
painted against the spontaneous rearrangement. If the cut position needs to be changet, it is possible to adjust the
knife position in the program.
Be sure to use the same size of the knife eye. When using the different eye size, the buttonhole will deform, or the
eye stitches can be damaged.
The point of departure for the cutting mechanism adjustment is the needle and sewing mechanism. The process is
choosed by installing the knife, either to the cutting lever or to the anvil.
8.1.
The knife installed into the cutting lever
3
,adjust in the axis X after loosing the nuts
1
, tighten the nut
2
,
on which side the cutting lever should be shifted. Zero position for adjustment is set by the manufacturer. To check
the cut use the paper sheet.
8.2.
The knife stop adjustment in the axis Y
in the cutting lever, adjust for 68mm after loosing the screws
4
.
Check by needle puncture on the paper in basic position with the button for cutting. The distance from the eye top to
the puncture has to be 64-0,3 mm.