0,5 - 0,7 mm
S-311+I
1-23 I
Released: 01/2014
E-mail: [email protected]; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
3. SETTING UP THE DISTANCE BETWEEN CLAMPING FEET
Change the distance between clamping feet
1
if you want to change workpiece or number of buttonholes to be
sewn.
3.1. Take out screws
2
of the right holder
3
and adjust the required distance X between the
Indexer clamping feet
1
and clamping mats
4
of the sewing head feet.
3.1.1. The minimal distance
X
can be found in
display pre-set parameters.
Example:
You wish to sew 4 buttonholes with the distance of 25 mm between them. The total length is 75 mm (the first
buttonhole is always sewn in indexer home position).
X = (number of buttonholes -1 fixed in place) x
distance between them + 2 mm (minimal play
between Indexer feet and clamping mat of the
sewing head; see chapter 2).
X = (4-1) x 25 +2 = 77 mm
Minimal distance must be adjusted to 77 mm.
If the minimal distance is shorter, the display
signals an error message
– the
required operation cannot be performed.
3.2. Secure the correct position by screws.
Do not forget to adjust the play between a
clamping foot and desktop ( see chapter 1).
3.3. Check the setting by pressing the button
. The device must move freely without
stopping.
Note:
Setting up the distance between clamping
feet needs to be done always by changing the
position of the right clamping foot of the Indexer
only!