Ametek Thermox WDG-V UOP, Руководство пользователя

Страница: 66 / 96

4-6 | Thermox WDG-V UOP IECEx/ATEX
Retrofitting the WDG-V UOP to WDG-IV UOP
These instructions require that each WDG-V UOP sensor is paired
with its own AMEVision as described in the Single Sensor Analyzer
Connection diagram.
Follow these instruction when retrofitting the WDG-IV UOP that uses
the Series 2000 controller to the WDG-V UOP using AMEVision and the
AMEVision display unit.
1. Disconnect customer wiring and conduit entries from the existing
WDG-IV UOP electronics enclosure.
2. Series 2000 Controller: Mark all wires with their corresponding Series
2000 circuit board terminal designation (see Figure 4-3).
3. Disconnect wiring and conduit entries from the existing Series 2000
control unit.
4. Remove the existing WDG-IV UOP Sensor from the process flange
and the Series 2000 controller from the installation.
5. Install the new WDG-V UOP Analyzer and AMEVision controller
as described in the standard installation instructions included in the
manual.
6. Using the existing wiring and conduit entries remaining from the
WDG-IV UOP Analyzer and Series 2000 Controller, reconnect as
shown in Figure 4-3.
7. Match up the numbered terminals on the terminal strip to the previ-
ous Series 2000 circuit board terminal designations (Step 2) that should
be marked on the wires in the AMEVision.