35
98-0155 Rev. C
6.0 MROZ CONTROLLER
6.1 FRONT PANEL CONTROLS AND INDICATORS
FIGURE 6.1
DISPLAY
- Shows status of system.
ALARM LAMP
- Flashes when fault causes an RO system shut down. On
steady when a Set point is exceeded that does not cause
an RO system shut down.
POWER KEY
- Places controller in operating or standby mode.
LEFT ARROW KEY
- Scrolls through Set points starting with first Set point.
RIGHT ARROW KEY
- Scrolls through Set points starting with last Set point.
UP ARROW KEY
- Increases value of Set point.
DOWN ARROW KEY
- Decreases value of Set point
ENTER KEY
- Confirms entry of new Set point value
ALARM SILENCE/RESET KEY - Push once for alarm silence and twice to reset system
after a shutdown has occurred.
ACCESSING DISINFECT MODE - Push and hold the left arrow key, and then push the right
arrow key.
(NOTE: The J2 jumper must already be installed to make this an active mode.)
(Refer to Figure 6.2)
DISINFECT
- Push the ENTER key and hold until all of the solution is
drawn into the MROZ.
DISPLAY
Содержание MRO3Z
