STRATOS VERTICAL PLATFORM LIFTS:
Install Manual
04DEC2020 | 630-00147 REV A
14
INSTALLATION
STRATOS: SECTION 4
INSTALLING A PLATFORM
GATE (IF EQUIPPED)
1. Align platform gate assembly on platform end
with floor and platform panels.
2. Install four (4) 1/4
"
-20 x 5/8
"
screws through
tabs in gate frame into threaded holes on
platform panels. See Figure 4-4.
Screws
Figure 4-4
3. Install three (3) 1/4
"
- 20 x 1
"
thread forming
screws through bottom tube of gate frame.
Screws are accessed through 7/8
"
diameter
holes in front of tube. Use a 3/8
"
nut driver
or socket and extension to tighten screws.
DO NOT USE AN IMPACT TOOL TO TIGHTEN
SCREWS.
4. Route platform gate wire harness from gate
over to safety pan 2-pin (safety pan) and 4-pin
(platform gate harness) connector.
INSTALLING THE PLATFORM
FRONT GUARD PANEL
Insert the front guard panel posts into the pockets
on the platform with the smooth side facing the
inside of the platform. Fasten in place with four (4)
1/4
"
-20 x 2
"
bolts.
If an auto fold ramp option is being installed the
ramp brackets must be installed with this hardware.
INSTALLING THE
AUTO-FOLDING RAMP
1. Attach the two ramp pivot tabs to the lower
landing sides of the platform using three (3)
¼
"
-20 x 2
"
bolts that go through the guard
panel post, and thread into the platform.
NOTE: If a platform gate is equipped, the pivot tabs mount
to the face of the gate with different hardware and nuts.
2. Assemble ramp roller arm into the rectangular
pocket of the ramp with the provided
hardware. See Figure 4-5.
Ramp
Pivot Tabs
Rectangular
Roller Arm
Figure 4-5
3. Use shoulder bolts to attach the ramp to the
pivot tabs.
4. To install the ramp roller guide, remove the
inside top and bottom side panel screws.
See Figure 4-6.
