In
tr
od
u
c
tio
n
A
p
pe
ndi
x
Tr
o
u
b
les
ho
o
ti
ng
Co
nf
igu
rat
ion
Ho
m
in
g Clo
ck
Firm
w
ar
e
Up
dat
e
Fa
ct
or
y D
efau
lts
R
est
ore
B
u
tt
o
n
O
p
er
at
ion
In
st
al
lat
ion
S
p
ec
if
ic
at
ions
© American Time
12
Wi-Fi Installation Manual
Introduction
The clock will act as a limited access point for direct Wi-Fi communication to complete configuration.
After connecting to the clock with a wireless device it can be configured with a web browser.
n
Note:
If your clock was preconfigured by American Time this process is unneeded unless changes are required.
Analog Configuration
To enter configuration (limited access point mode) complete the following process:
Analog Battery Clocks:
Apply power to Wi-Fi module by inserting the barrel plug (C) of the battery pack into the
left side of the Wi-Fi module where the power connection is located.
Analog Electric Clocks:
Apply power to Wi-Fi module by inserting the barrel plug of the power cord into the left
side of the Wi-Fi module where the power connection is located for the electric clocks. Insert the other end of the
power cord into the appropriate power source.
n
Note:
If red gear locking pin (A) has not been removed, remove it prior to applying power.
1. Verify the LED (B) starts flashing red.
2. Wait for the LED to either stop flashing (Battery clock) or turn a solid color (Analog clock).
3. Press and hold the button located on the middle of the Wi-Fi module.
a. The LED (B) should turn solid green to indicate the button press (continue holding the button).
b. Wait for the LED (B) to flash orange one time.
This will take about 2 seconds (additional flashes indicate other modes).
4. Release the button.
a. Verify the LED (B) flashes green/orange indicating Limited Access Point mode is active.
5. Connect to the clock with a Wi-Fi enabled device (SSID will show up as American Time - xxxxxx
under available wireless networks, where xxxxxx is the last 6 digits of the mac address.
6. Enter
192.168.240.1
into the URL of a web browser of the Wi-Fi enabled device.
7. Refer to Clock Configuration (page 9) to configure clock settings and
Wi-Fi Configuration (page 14) to configure Wi-Fi settings.
8. Disconnect power from the Wi-Fi module by disconnecting the barrel plug (C) of the battery
pack from the left side of the Wi-Fi module where the power connection is located.
n
Note:
Power should be applied at the intended installation location to verify good Wi-Fi coverage.
Digital Configuration
To enter configuration (limited access point mode) complete the following process:
Ensure that the clock is powered up and move the Run/Set switch from Run to Set. The clock will display a
scrolling message:
SEtUP
. Press the Enter button and the clock Wi-Fi module will go into provisioning mode.
1. Connect to the clock with a Wi-Fi enabled device (SSID will show up as American Time - xxxxxx
under available wireless networks, where xxxxxx is the last 6 digits of the mac address.
2. Enter
192.168.240.1
into the URL of a web browser of the Wi-Fi enabled device.
3. Refer to Clock Configuration (page 13) to configure clock settings and Wi-
Fi Configuration (page 14) to configure Wi-Fi settings.
4. When the clock Wi-Fi module is connected to the Wi-Fi enabled device, the clock will
scroll the message:
CANCEL
across the screen. Press the Enter button to cancel the
provisioning and disconnect the Wi-Fi module from the Wi-Fi enabled device.
Configuration (Limited Access Point Mode)
