8
Note:
The detection distance is preset and is ideal for
most installations. Should an adjustment be required
follow the steps below.
1.
To remove the FRONT PANEL
(1)
, insert WIRE KEY
(2)
(supplied) into the two holes located at the bottom of the
FRONT PANEL
(1)
. Push the WIRE KEY
(2)
up until it
releases the bottom clips. Pull the bottom edge away
and lift the FRONT PANEL
(1)
off.
Fig. 13a.
2.
Pull out the POWER SUPPLY CONNECTOR
(3)
.
Disconnect and then reconnect the the POWER
SUPPLY CONNECTOR
(3)
.
Fig. 13b.
Note:
You will have 5 seconds after connecting both
connectors to enter the program code.
3.
While the SENSOR CONTROL LED
(6)
is blinking
slowly, place your hand 1 to 2 in. (30-50mm.) in front of
the sensor.
Fig. 14a.
4.
When the LED
(6)
stops blinking and stays "ON", move
your hand to the desired position from sensor (detection
zone, 1-1/2" to 31", 38 to 787mm ) and hold in place until
the LED
(6)
begins to blink again.
Fig. 14b.
Note: Detection Zone is 1-1/2" to 31", 38 to 787mm from
sensor.
5.
Once the SENSOR CONTROL LED
(6)
begins to blink
again, remove your hand from the detection zone. When
the flashing stops, the detection distance is set.
6.
Actuate the FLUSH VALVE:
A) Cover sensor with hand for 10 seconds.
NOTE:
Stand outside of sensor detection aera.
B) Remove hand from in front of the sensor; unit will
flush in approximately 3 seconds.
HOW TO SET DETECTION RANGE
(If Required) ; Fig. 13 & 14
Fig. 13
Fig. 13a
Fig. 13b
13
1
2
3
M965218 REV 1.8
6
6
Fig. 14
Fig. 14a
Fig. 14b
DETECTION ZONE
38mm TO 787mm
(1-1/2" TO 31")
1" - 2" (30mm - 50mm)
BLINKING LED
BLINKING LED
