American Sportworks Utility Vehicl, Руководство оператора

Страница: 14 / 135

14
Section 4 Operating Instructions
General Operation
Start your Utility Vehicle by following the starting
procedures as noted below.
1. Depress brake pedal with your foot and hold.
Pull firmly up on the park brake lever with your
hand until the lever is tight.
2. Place gearshift in neutral
3. Apply choke fully when engine is cold.
4. Turn ignition key fully clockwise and hold to stop
engine.
5. Release ignition key to run position and choke
to normal operating position immediately after
engine starts.
6 Turn ignition key counterclockwise to stop
engine.
Driving is as easy as driving a car with an automatic
transmission. A simple forward and reverse shifter
provides direction control.
Just turn the key and the 12 volt electric starter provides
safe and easy starting. There is a manual choke control
below the seat for quick cold weather starting. A back-up
pull-rope starter mechanism is provided on the engine
just in case you accidentally leave the key on and run
the battery down. The infinitely variable torque converter
drive system means there is no clutching. You just shift
into either forward or reverse when the vehicle is
stopped and press the throttle pedal to go. Never shift
while the vehicle is moving.
Braking is accomplished by simply depressing the brake
pedal that is located on the floorboard left of the
accelerator. A lever action parking brake control is
mounted on the center console located between the
operator and passenger seats. Depress the button on
the park brake control lever to release the park brake.
Pre-Start Check List
__
Check tire pressure as indicated.
__ Make sure wheel lug bolts/nuts are tightened to 65ft.
lbs.
__ All nuts, bolts, screws, and fasteners should be
checked.
__ Turn on headlights to make sure battery has a charge
and electrical lighting circuit is working.
__ Check tail lights and brake lights. (if applicable)
__ Check park brake to make sure it will engage, hold
and release.
__ Check steering by executing a full lock to lock turn in
each direction.
__ Check engine oil level at the dipstick. Add oil as
indicated.
__ Check differential oil level at the differential oil plug.
Add gear lube as indicated.
__ Check fuel valve lever position. Valve lever should be
off except when running the engine.
__ Check fuel level to make sure there is at least 1/8 of a
tank of gas prior to performing initial starting operations.