American Sportworks Utility Vehicl, Руководство оператора

Страница: 35 / 135

35
Transaxle Oil Change
Warm oil drains quickly and completely. Therefore, drain
used transaxle oil while transaxle housing is still warm
as follows:
1. Park vehicle on a level surface, set park brake,
turn off ignition switch, and remove switch key.
2. Place a suitable container below the transfer
case to catch used oil. Remove fill cap and drain
plug.
3. Allow used oil to drain completely and then
reinstall drain plug and tighten it securely.
4. Dispose of used transaxle case oil in a manner
that is compatible with the environment. Do not
throw used oil in the trash, pour it on the ground,
or down a drain.
5. Fill transaxle housing with 20 oz. SAE 30W oil.
6. Replace fill cap and tighten securely.
Figure 5-5B
Section 5 Maintenance
Drive Belt
The dive belt is considered a wearable item.
Replacement intervals depend on vehicle use and
environment. If your belt is slipping you may need to
replace it.
1. Park vehicle on a level surface, set park brake,
place shifter in Neutral, turn off ignition switch,
and remove switch key.
2. Remove the upper belt covers. (It is not
necessary to remove the bottom cover.
3. “Walk” the belt off of the rear pulley as shown in
Figure 5-6.
Figure 5-6
4. Install the new belt on the front pulley first and
“walk” it onto the rear pulley.
5. Reinstall the belt guards. Figure 5-7.
Attention: Failure to reinstall the belt guards may
void your warranty.
Figure 5-7