American Panel Blast Chiller AP40BC250-12, Руководство по установке и обслуживанию

Страница: 19 / 42

PROGRAMMING
17
D. Programming The Controller
WARNINGS!
Read and carefully follow all of the instructions in this manual before attempting to install this equipment.
Installation must be performed by a qualified Service Agency approved and authorized by American Panel
Corporation. Doing otherwise may void the warranty.
Any changes made to the equipment without authorization from the factory will void the warranty.
PREPARATION
9
Check the integrity of the unit once it is unpacked.
9
Check to make sure the floor is level.
9
Check that the available power supply (Voltage, # of phases, Hz, Amps, max. fuse size) corresponds to the ratings on
the nameplate and that correctly rated electrical protection is provided ( VOLTAGE MUST BE WITHIN
±
5% FROM
THE NAMEPLATE VALUE ).
9
Make certain that adequate drainage is provided.
D.1. Blast Chilling Modes
AP40BC250-12,
AP40BC250-2-12, BCCP-1, BCCP-2, and BCIP are equipped with a high versatility electronic
controller allowing the chef to choose between automatic and manual operation.
Automatic Mode
In the first part of the cycle the air temperature is lowered to a preset temperature (10
0
F). When the food core
temperature reaches a preset breaking temperature point (60
0
F) the unit will switch to the second part of the cycle which
is design to protect the food from getting frozen. The air temperature will rise to a preset temperature range (28
0
F to
35
0
F). The chilling cycle is complete when the food core temperature reaches the desired end temperature (40
0
F).
Manual Mode
In the manual mode the blast chilling operation will last for a preset time. In the first part of the manual cycle the
air temperature is lowered and held to a preset temperature (10
0
F). Once the time for the first part of the cycle expires the
unit will switch to the second part of the cycle. The air temperature is held at a preset temperature range (28
0
F to 35
0
F) for
the remaining time (1 hour).
Note: At the end of any blast chilling cycle the unit will automatically switch to a holding mode which will keep the food at
38
0
F until START/STOP button is pressed to end the cycle.
D.2. PC Connection Mode
The unit can be programmed and operated from a remote PC via modem and software (Windows 95, 98, 2000,
NT, and XP). Maximum distance is 4000 feet. Full instructions are supplied on a computer disc, which is furnished when
the computer connection is ordered. All connections should be made exactly as shown in the connection diagram, drawing
number 98002-01B on page 38 of this manual.
The application allows the operator to save the programmed parameters and the events memory to PC for
archival purposes. The software’s interface emulates the control panel.