Page 9
TEMPERATURE CONTROL
Set the Desired Temperature
1.
The temperature adjustment range is 95
o
F - 149
o
F (35
o
C – 65
o
C)
2.
Press the “OFF/ON” key. The temperature display unit lights up and displays the current
temperature set point. The factory default set point is 107
o
F (42
o
C).
3.
Press the “UP” or “DOWN” key to set any desired temperature between 95
o
F (35
o
C) and
122
o
F (50
o
C). The temperature set point goes up or down by one degree with each press.
4.
To set a temperature above 122
o
F (50
o
C): Press and hold the “UP” key continuously for
about 4 seconds until 131
o
F (55
o
C) is displayed.
5.
Note: When the temperature is above 122
o
F (50
o
C), each press of the “UP (DOWN)” key
causes the temperature to go up (down) by 5
o
C (9
o
F).
6.
When the desired temperature is set above 122
o
F (50
o
C), the temperature display blinks
for approximately 4 seconds before the display switches to show actual water temperature.
7.
Along the left side of the temperature display, a series of bars indicates the level of the
temperature set point. At each 5
o
C (9
o
F) increment, an additional bar lights. When the set
point is above 122
o
F (50
o
C), the first red bar appears indicating the set point is in a zone
where a scalding hazard exists.
8.
The heater will retain the temperature set point unless there is a loss of power.
9.
After the temperature is set, open the water valve and observe. The “Combustion”
indicator should light indicating the unit is operating normally.
SCALD PREVENTION
o
Water temperatures over 125
o
F will scald and can
instantly cause severe burns or death!
o
Children, disabled and elderly are at highest risk of
being scalded
o
Always test the water temperature by feeling the water
prior to entering a shower, bath, etc.
o
Obey all codes regarding temperature set point.
Contact a licensed plumber or local plumbing authority
for clarification or additional information.
Содержание AHG-T42-LP
Страница 38: ...Page 38...
