American Hometec AHG-T42-LP, Инструкция по установке и эксплуатации

Страница: 5 / 48

Page 5

This equipment may not be operated without the vent pipe properly connected. The
exhaust pipe must not terminate in an area where the exhausting vapor or collecting
condensate could create a hazardous situation or cause property damage. Exhaust gases
must be vented out of the building in compliance with all building codes.

The exhaust piping is very hot during and for a period after use. Do not touch the pipe.

Ensure that snow, ice or other debris does not block the inlet or exhaust pipes.

Regular housekeeping should be done in areas around the heaters to prevent insect
intrusion and possible equipment malfunction.

The unit should be serviced on a routine basis to ensure optimum performance. Service
needs will vary based on local water conditions including acidity, alkalinity, hardness, etc.

Freezing temperatures will cause damage to the heater. Install in locations where freezing
temperatures are not reached and follow procedures to drain the unit if it will be out of
service for a period of time.

A 120 V / 60 Hz power source should be used. Fire, electrical shock or damage to the water
heater may occur if an incorrect power supply is used.

This appliance is equipped with a three-prong grounded plug for increased protection
against electrical shock. Ensure the plug is properly inserted into a clean, dry outlet that
complies with all electrical codes. Only insert and remove the plug using the plug head and
never use a wet hand to plug or unplug the power plug.

Any alterations to the appliance will void the warranty.