11
Installation and Operation Manual
System Warnings
The
Warnings
screen displays warnings and important system information. It is important to follow any warnings or
advice given on this screen in order to obtain optimal performance from the MegaPower 48+ system.
To display the
Warnings
screen, click the
Entire Site
node on the left-hand side of the display area. In the resulting
screen, click the
Warnings
tab.
Monitor Status
To display the
Monitor Status
screen, click the
Monitor Status
node on the left-hand side of the display area. This
screen displays real-time status information for each system monitor. This screen is read-only.
Monitors are listed by their monitor identification number, with port references shown in brackets. In the port reference,
the first character refers to the matrix to which the monitor is connected (X = primary unit, A-F = secondary unit) and the
second and third characters are the port number on that matrix (1-16).
The screen displays the following information:
•
Camera
shows the video input number currently being displayed on the monitor.
•
Sync
indicates whether a video synchronisation signal is detected on the currently displayed video input.
•
Tour
indicates the number of the tour currently running on the monitor. If no tour is running,
0
is displayed.
•
Hold/Run/Salvo
shows the status of a tour (
Run
or
Hold
) called to the monitor or
Salvo
if the camera currently
called to the monitor is part of a salvo.
•
Alarm
indicates if a system alarm is currently displayed on the monitor.
•
Lock Status
shows whether the monitor is locked or unlocked. When the monitor is locked, the on-screen status
display does not change when video is switched. When the monitor is unlocked, the on-screen status display does
change when video is switched.
Note
When video loss detection is enabled in the
Options
screen (see page 16), the monitor with port reference X16 is used
by the system to sample video and will therefore be not be available for video switching.
