ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 12
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 11
System Menu: When confirming your setting press ENTER
and then hold MENU for at least 2-3 seconds, or you can
wait 1 minute for automatic setup. To exit without making
any adjustments press the MENU button.
ADDR
-
DMX Address Setting via control board.
1. Press the MENU button until “ADDR” is displayed, press ENTER.
2. “X” will now be displayed, “X” represents the displayed address.
Press the UP or DOWN buttons to find your desired address.
3. Press ENTER to confirm, then connect your DMX controller.
NOTE: If after you connect your DMX controller the unit does not fall
into DMX mode, press and hold the MENU button for at least 3 sec-
onds.
SLND -
This will let you set unit as a slave in a master/
slave configuration.
1. Press the MENU button until “SLND” is displayed, press ENTER.
Either “SL 1” or “SL 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one fixture the
Master and then set the next fixture to “SL 2”, the fixtures will now
have contrast movement to each other.
SOUN
-
In this mode you can run in sound active mode.
1. Press the MENU button until “SOUN” is displayed, press ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or DOWN
buttons to select one or the other.
3. When you have made your selection, press the ENTER, and then
press and hold the MENU button for at least 3 seconds to confirm.
Royal 3D II System Menu
Royal 3D II
System Menu
