©American Audio® - www.americanaudio.eu Versadeck™ User Manual Page 68
21.
C
ROSSFADER
R
EPLACEMENT
The crossfader is “Hot Swappable” which means
it may be replaced at any time, even when power
is applied. Only replace with American Audio Part
Feather Fader Plus. Replacing with any other
model fader may seriously damage your mixer.
Please, always use insulated tools.
R
EPLACING
H
OW
-T
O
1.
Using a Phillips screw driver, unscrew the six stainless steel retainer screws that hold
the mixer face plate in place.
2.
Gently remove the crossfader knob. Lift and remove the mixer face plate to access the
cross fader. Carefully pull the crossfader up from its seated position.
3.
After removing the crossfader, disconnect the ribbon cable that attaches the crossfader
to the PC board. Grasp the crossfader by its base and pull the ribbon cable by its
connector not the actual cables. The connector is designed to only fit one way, so don’t
worry about the connector’s orientation.
4.
Unscrew the ground cable from the crossfader plate. Now unscrew the crossfader from
the crossfader plate and replace with the new crossfader. Connect the ground cable to
the cross fader plate.
5.
Connect the new crossfader to the ribbon cable and replace in reverse order.
Note:
All other areas of the
Versadeck™
are not to be opened or replaced by user, dealer, or
un-authorized service centers. These actions will result in a voided warranty.
