©American Audio® - www.americanaudio.eu Versadeck™ User Manual Page 30
10.3
F
RONT
P
ANEL
(37) Microphone 1 Jack
– This jack accepts a standard 1/4 plug. The volume output level for
this microphone will be controlled by its own respective
Mic Knob (38)
.
Note:
We
recommend that you use a 500-600 ohm microphone for the best sound quality.
(38) Microphone 1 Volume
– This knob is used to regulate the microphone 1 output volume.
Turning the knob in a clockwise direction will increase the volume level.
(39) Microphone 2 Volume
– This knob is used to regulate the microphone 2 output volume.
Turning the knob in a clockwise direction will increase the volume level.
(40) Mic Tone Control
– This knob controls the frequency response of the microphone.
(41) Talkover Control
– This function decreases all signal output except for the microphone
signal.
(42) Cue Mix
– This slider is used to send a channels’ incoming signal to the headphones.
Slide the slider to the left to monitor Channel 1, and to the right to monitor Channel 2. The
cue level is adjusted by the
Cue Level Volume Knob (43)
. Be sure the cue level is set to
minimum before putting a pair of headphones on.
(43) Cue Level Volume Knob
– This knob is used to adjust the headphones volume output
level. Turn the knob in a clockwise direction to increase the headphones volume.
(44) Headphones Jack
– This jack is used to connect your headphones to the mixer, allowing
you to monitor the cue source. Use headphones only rated at 8 ohms to 32 ohm. Most DJ
headphones are rated at 16 ohm, these are highly recommended. Always be sure the
Cue
Level Volume (43)
is set to minimum before you put the headphones on.
