AMCI NEXUS NX2A4E2, Руководство пользователя

Страница: 27 / 76

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
NX2A4E2 User Manual
D
ATA
F
ORMATS
27
Input Data Formats (continued)
Dual Resolver Data Format (continued)
Channel Status Word (continued)
Bit 08: Motion_Direction – Reset to “0” when the counts are increasing. Set to “1” when the counts are
decreasing. This bit remains in its last state when no motion is occurring.
Bit 07: Message_Ignored – Set to “1” when you attempt to program a parameter or channel if a parameter
error has already been flagged for a different parameter. This bit is also set to “1” if you attempt to
preset the position on a channel that is in transducer fault.
Bit 06: Command_Err – Set to “1” under the following conditions:

Any of the reserved bits in the command words are set to “1”

You attempt to program more than one channel at a time

You attempt to preset channels 2 or 4 when they are part of a dual-resolver channel.
Bit 05: Preset_Err – This bit is set to “1” when you attempt to program the channel’s Preset Value parameter
outside its valid range of Linear Offset to (Linear Offset - (Full Scale Count – 1)).
Bit 04: LinearOffset_Err – Set to “1” when you attempt to program the channel’s Linear Offset parameter
outside its valid range of 0 to 999,999.
Bit 03: FSC_Err – This bit is set to “1” when you attempt to program the channel’s Full Scale Count param-
eter outside its valid range. Valid ranges are:

2 to (4,096 * Number of Turns) for 100 or 180 turn transducers

2 to (409.6 * Number of Turns) for 1,000 or 1,800 turn transducers

2 to (1,024 * Number of Turns) for 128 turn transducers
Bit 02: NumTurns_Err – This bit is set to “1” when you attempt to program the channel’s Number of Turns
parameter outside its valid range. Valid ranges are:
Bit 01: TType_Err – This bit is set to “1” when you attempt to program the channel’s Transducer Type
parameter outside its valid range of 100, 180, 1,000, 1,800 or 128.
Bit 00: Config_Err – This bit is set to “1” if any of the reserved bits are set to “1” when the channel is pro-
grammed.
Transducer
Type
Available Number of Turns
100 1, 2, 4, 5, 10, 20, 25, 50, 100
180 1, 2, 3, 4, 5, 6, 9, 10, 12, 15, 18, 20, 30, 36, 45, 60, 90, 180
1,000 10, 20, 40, 50, 100, 200, 250, 500, 1,000
1,800
10, 20, 30, 40, 50, 60, 90, 100, 120,
150, 180, 200, 300, 360, 450, 600, 900, 1,800
128 1, 2, 4, 8, 16, 32, 64, 128