General safety instructions
24
Cenius03-2TX BAG0112.13 07.21
Machine transportation
•
When using public highways, national road traffic regulations
must be observed.
•
Before moving off, check:
ο
the correct connection of the supply lines
ο
the lighting system for damage, function and cleanliness
ο
the brake and hydraulic system for visible damage
ο
that the parking brake is released completely
ο
the proper functioning of the braking system
ο
the bearing frame parts for damage.
•
Ensure that the tractor has sufficient steering and braking power.
Any machines and front/rear weights connected to the tractor
influence the driving behaviour and the steering and braking
power of the tractor.
•
If necessary, use front weights.
The front tractor axle must always be loaded with at least 20% of
the empty tractor weight, in order to ensure sufficient steering
power.
•
Always fix the front or rear weights to the intended fixing points
according to regulations.
•
Comply with the maximum load of the connected machine and
the approved axle and support loads of the tractor.
•
The tractor must guarantee the prescribed brake delay for the
loaded vehicle combination (tractor plus connected machine).
•
Check the brake power before moving off.
•
When turning corners with the machine connected, take the
broad load and balance weight of the machine into account.
•
Before moving off, ensure sufficient side locking of the tractor
lower links, when the machine is fixed to the three-point hydrau-
lic system or lower links of the tractor.
•
Before moving off, move all the swivel machine parts to the
transport position.
•
Before moving off, secure all the swivel machine parts in the
transport position against risky position changes. Use the
transport locks intended for this.
•
Before transporting, secure the operating lever of the three-point
hydraulic system against the unintentional raising or lowering of
the connected/hitched machine.
•
Check that the transport equipment, e.g. lighting, warning
equipment and protective equipment, is correctly mounted on the
machine.
•
Before transportation, carry out a visual check that the upper and
lower link pins are firmly fixed with the lynch pin against uninten-
tional release.
•
Adjust your driving speed to the prevailing conditions.
•
Before driving downhill, switch to a low gear.
•
Before moving off, always switch off the independent wheel
braking (lock the pedals).
Содержание Cenius 4003-2TX
Страница 50: ...Structure and function 50 Cenius03 2TX BAG0112 13 07 21 Cenius 5003 2TX Fig 19 Cenius 6003 2TX Fig 20...
Страница 51: ...Structure and function Cenius03 2TX BAG0112 13 07 21 51 Cenius 7003 2TX Fig 21 Cenius 8003 2TX Fig 22...
Страница 102: ...Cleaning maintenance and repairs 102 Cenius03 2TX BAG0112 13 07 21 Fig 60...
Страница 126: ......
