Amazone Cenius 4003-2TX, Руководство по эксплуатации

Страница: 112 / 126

Cleaning, maintenance and repairs
112 Cenius03-2TX BAG0112.13 07.21
Checking the play on wheel hub bearings
1. To check the play on wheel hub bearings,
raise the axle until the wheels turn freely.
2. Release the brake.
3. Place a lever between the tyre and the
ground and check the play.
If bearing play can be detected:
Adjust the bearing play
1. Remove the dust cup or hub cap.
2. Remove the split pin from the axle nut.
3. Tighten the wheel nut while turning the
wheel at the same time until the wheel hub
is lightly braked as it turns.
4. Turn axle nut back to the next available split
pin hole. To the next matching hole (max.
30°).
5. Fit split pin and bend slightly open.
6. Top up the dust cap with high melting point
grease and drive it into, or screw it onto the
wheel hub.
Fig. 73
Fig. 74
Brake pad check
To check the brake pad thickness, open the in-
spection hole (1) by opening the rubber tab.
Changing the brake pads
→
Workshop work
Criterion for changing the brake pads:
• Minimum pad thickness of 5 mm was
reached.
•
Wear edge (2) was reached.
Fig. 75