DTMF Programming
3-6
Installation and Programming Manual
Table 3-1 PBX Parameter Commands (continued)
OPERATION
COMMAND
DEFAULT
Busy, Disconnect
and DTMF
Off/On time
*371 + X + YYYY
where:
X = 1; busy off (0100-3000 ms)
X = 2; busy on (0100-3000 ms)
X = 3; Disconnect off (0100-3000 ms)
X = 4; Disconnect on (0100-3000 ms)
X = *; DTMF off (0000-3000 ms)
X = #; DTMF on (0000-3000 ms)
YYYY = Cadence in milliseconds in steps of 20
milliseconds.
500 ms
500 ms
240 ms
240 ms
200 ms
60 ms
Busy Signal
Cadence Check
*375 + XXXX + #
where XXXX is a busy extension number.
Check the busy signal by dialing the busy extension
number and playing the busy cadence values.
Voice and DTMF
Sensitivity
*376 + X + Y
X = 1; Voice sensitivity level
X = 2; DTMF sensitivity level
Y = Sensitivity level (0-9)
The volume at which the MiniSOHO detects voice
when the called extension answers or the volume
level at which the MiniSOHO detects DTMF
throughout it’s operation.
Note: The higher the sensitivity level, the
higher the sensitivity to voice or DTMF.
In order to activate the new selection, a new call
must be initiated.
5
Automatic Gain
Control (AGC)
*377 + X
X = 0 AGC disabled
X = 1 AGC enabled
When enabled, The MiniSOHO will adjust the
incoming messages volume to a set volume level.
Note: For the new value to take affect, a new call
must be initiated.
Enabled
DTMF amplitude
*379 + X
where X = volume level (3-9), 9 = Loudest
5
