Amada S-2200CA, Руководство по эксплуатации

Страница: 77 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 3-23
Move the cursor

to the required item then press the ENTER key; the data will be copied.
a.
Power Supply

MA-660A .
The data in the Power Supply is copied to MEMORY of MA-
660A.When copy is complete, <END> is displayed.
b. Power Supply

MA-660A. The data in MEMORY of MA-660A is copied to the Power
Supply. When copy is complete, <END> is displayed.
c.
SCHEDULE [A]

SCHEDULE [B]–[C].
This function is used to copy the SCHEDULE
(welding condition).The Power Supply can set up to 255 schedules, indicated as SCHEDULE
#1 – #255.This function is also used to change from the SCHEDULE #1 setting, to perform
welding according to another schedule.
EXAMPLES :
•
Schedule #2 can be set by switching from SCHEDULE #1 as follows:
−
SCHEDULE 001

SCHEDULE 002 – 002 .
Be sure to press the
ENTER
key before
moving the cursor).
−
Move the cursor to the left of the letters of SCHEDULE and press the ENTER key. The
data for
SCHEDULE #1
is copied to
SCHEDULE #2
through this operation. Call up #2
on the SCHEDULE screen , and change the values, if necessary.
•
SCHEDULE #1 can be copied immediately to SCHEDULE #2 via SCHEDULE #4 through
the following setting:
−
SCHEDULE 001 -----> SCHEDULE 002 - 004
NOTE: Do
not
operate the program unit until the copy is complete.
(a)
(b)
(c)