Amada S-2200CA, Руководство по эксплуатации

Страница: 101 / 210

CHAPTER 3: USING PROGRAMMING FUNCTIONS
IS-2200CA/4500CA INVERTER POWER SUPPLY
990-412 3-47
13. I/O CHECK Screen
This screen is used to check the status of the external I/O signals. The “*” symbol appears when
the corresponding input signal is ON. The asterisk disappears if the signal is OFF. Set the cursor
reading to “0” to turn OFF the output signal, and “1” to turn it ON. Reception of an input signal
while this screen is showing will not activate the corresponding function. You cannot move to
another screen while the 1ST or 2NDSTAGE signal is input.
I/O Terminal Board (see Appendix B for user accessible I/O’s)
Input signal
SCHEDULE 1 SCHEDULE 128 ERROR RESET
SCHEDULE 2 PARITY STEP RESET
SCHEDULE 4 WELD COUNT COUNT RESET
SCHEDULE 8 WELD CONT STAGE 1
SCHEDULE 16 THERMOSTAT STAGE 2
SCHEDULE 32 FLOW SWITCH RETRACTION 1
SCHEDULE 64 BACK STEP RETRACTION 2
STEP MODE
Output signal
NG1 OUT (ERROR) VALVE1 (SOL1)
NG2 OUT (CAUTION) VALVE2 (SOL2)
OUT1 EX VALVE1 (EX SOL1)
OUT2 EX VALVE2 (EX SOL2)
OUT3 EX VALVE3 (EX SOL3)
OUT4 EX VALVE4 (EX SOL4)
OUT5 RET VALVE1 (RET SOL1)
RET VALVE2 (RET SOL2)
VALVE RELAY (SOL RELAY)