Alvarion BreezeMAX PRO-S CPE, Руководство по эксплуатации продукта

Страница: 56 / 162

34 BreezeMAX CPEs Product Manual
Chapter 2 - Installation
1
It is assumed that the IDU-ODU cable is already connected to the ODU.
Assemble an RJ-45 connector with a protective cover on the indoor end of the
IDU-ODU cable. Refer to
Section 2.1.6.3 for instructions on preparing the
cable.
2
Connect the IDU-ODU cable to the RADIO connector. The RADIO connector in
the CPE-IDU-1D is located on the front panel as shown in
Figure 2-9 .
3
Connect the power cord to the unit's AC socket, located on the rear panel.
Connect the other end of the power cord to the AC mains after verifying that
the unit is rated for the voltage in the country of use; the AC range is indicated
on the back side of the CPE-IDU-1D.
4
Verify that the POWER LED located on the front panel is lit, indicating that the
unit is supplying power to the radio port.
5
Configure the basic parameters and align the antenna as described in the
applicable sections of
Chapter 3 .
6
Connect the 10/100 Base-T ETHERNET connector(s) to the data equipment.
The cable connection should be a crossed Ethernet if connecting to a
hub/switch and a straight cable if connecting directly to a PC Network
Interface Card (NIC).
7
Verify proper operation as described in the applicable section of Chapter 3 .
CAUTION
Do not connect the data equipment to the RADIO port. The RADIO port supplies DC power to the
ODU, and this may harm other equipment connected to it.
NOTE
The color codes of the power cable are as follows:
Brown
Phase ~
Blue Neutral 0
Yellow/Green Ground
NOTE
The length of the Ethernet cable connecting CPE-IDU-1D to the user's equipment, together with the
length of the IDU-ODU cable, should not exceed 100 meters.