Alvarion BreezeMAX PRO 5000 CPE, Руководство по эксплуатации продукта

Страница: 88 / 116

Chapter 4 - Operation Radio Parameters
BreezeMAX PRO 5000 CPE 71 Product Manual

Delete All Discrete Frequencies: to delete all discrete frequencies, click on
Delete All.

Discrete Scanning Frequencies: enables to enter discrete frequencies, as
follows:
» Update List of Discrete Frequencies: Enter a list of up to 10 discrete
frequencies in steps of 2.5MHz, separated by commas (no space). This list
will replace the current list of discrete frequencies.
» Add One Discrete Frequency: Enter one frequency to be added to the
current list of discrete frequencies.

Update Scanning Table: select this option to update the frequency scanning
table in run time (without resetting the unit).

Clear Best BS Table: select this option to clear the current Best BS Table.
Typically this should be done prior to initiating a full scanning process (see
below).

Force Full Scanning: select this option to initiate a full scanning process. The
BS table is cleared automatically.
4.8.3 Antenna Selection
The Antenna Selection page enables viewing the parameters of the integrated and
external antennas. The following parameters are displayed:

Radio Status

Antenna Gain: enables configuration of the external antenna gain (shown only
if the CPE is configured with an external antenna). Enter the gain value for the
external antenna and click Apply. The message “Antenna Param Set, done!” is
displayed. This operation requires a CPE reboot in order for the change to take
effect.
Figure 4-13: Antenna Selection Page