Alvarion BreezeACCESS II, Системное руководство

Страница: 236 / 324

2-106
BreezeACCESS Version 4.5 Operations and Administration
Manual Revision: 1.0
" Stop Dialing Indicator: - contols the use of the # sign to
indicate end of dialing, thus to speed the dialing process. The
options are:
#
Disable: The # sign is interpreted as a part of the dialed
sequence. End of dialing is determined by the Stop Dialing
Timeout parameter.
# Enable: The # sign is interpreted as indicating end of dialing
sequence.
The default is Disable
! Telephone Number – The telephone number as specified in the
Gateway (if it is required by the specific type of Gateway used).
Valid values: up to 10 digits (0-9).
The default number is 0000....0 (10 zeros) .
! H323 Terminal ID – The H323 Terminal ID (Name) to be used for
calling the terminal when the caller uses this feature (e.g.
NetMeeting).
Valid values: up to 24 characters.
The default selection is X (No H323 Terminal ID) .
!
Automatic Prefix – specifies a default prefix (number of the
Gateway trunk port) to be automatically inserted and transmitted to
the gateway before the dialed number. The Automatic Prefix will be
inserted only if the
Dialing Option parameter (see below) is
disabled, or if it is enabled and the first dialed digit is different from
the defined Inter-Regional Prefix.
Valid values: up to 8 phone key-pad digits (0-9, *, #, A, B, C, D)
The default is X (no Gateway Prefix) .
!
Fast Start – Enables or disables the fast connect protocol, which is
a H.323 Version II feature that allows decreasing the connection
set-up time (if supported by the Gateway).
The original procedure prior to H.323 Version II required four round
trips of messages between endpoints before the first media stream is
exchanged between peers. Fast Connect, or Fast Start, is a new
procedure added to H.323 version II. It reduces the number of
round trips to one by combining the call connect procedures into a
single H.225 transaction.
The default selection is Enable .
!
Information Transfer Capability – To define the value of the
information transfer capability element in the Q.931 SETUP
message.
NOTE:
When using a Gateway without a Gatekeeper, this number must be predefined in the
Gateway