![Alvarado SU4500 Скачать руководство пользователя страница 37](http://html1.mh-extra.com/html/alvarado/su4500/su4500_user-manual_2915088037.webp)
Supervisor 4500 User Guide
Page 37 For Assistance: [email protected] +1 (909) 591-8431
PUD4386R1-1
SU4500 Configuration Preparation
SU4500 configuration changes are broken down into two sections: configuring the turnstile operating
system, and configuring the turnstile application. Each type of configuration requires a different
configuration tool.
Configuring the turnstile operating system is accomplished using the
UltraVNC Viewer
application (included
on the File Management USB provided with the turnstile). Configurable operating system settings include
the system time, IP address, and speaker volume. Typically, operating system settings are configured
before turnstile application settings.
Configuring the turnstile application is accomplished using the
LaneConfig
(also included on the File
Management USB). Configurable turnstile application settings include alarm sounds, detection settings, and
alarm timer settings. Instructions on using LaneConfig can be found in the
LaneConfig User Guide
located
on the File Management USB.
There are two ways to connect to the turnstile: 1) via a computer on the facility network (if networked), or
2) via a local laptop computer connected directly to the turnstile (if not networked). Keep in mind that newly
installed turnstiles that will be networked must first be configured using a local laptop computer to set the
network IP address.
This User Guide assumes you are configuring newly installed turnstiles via a local laptop computer. If
your turnstiles are already networked and configured with a network IP address, refer to the
LaneConfig
documentation for installation and configuration instructions.
Perform the following configuration steps for newly installed turnstiles.
Install Configuration Tools
1. UltraVNC Viewer
2.
LaneConfig
Connect Laptop Computer to the Turnstile
1. Remove base cover to access Ethernet adapter.
2. Connect laptop computer to the Ethernet extension cable using an Ethernet cable.
Configure Operating System Settings Using UltraVNC Viewer
1. Set local system time.
2. Set turnstile IP address (required for networked turnstiles).
Configure Turnstile Software Settings Using LaneConfig (optional)
1.
Configure turnstile parameters.
The factory default settings are appropriate for most installations. If the facility requires a particular turnstile
setting to be changed, change it at this time.
Overview
New Installation Configuration Checklist
NOTE
Содержание SU4500
Страница 2: ...This page intentionally left blank...