Supervisor 4500 User Guide
Page 50 For Assistance: [email protected] +1 (909) 591-8431
PUD4386R1-1
Appendix A - Configuring Dynamic Lights (Optional)
The acrylic side panels are illuminated by Dynamic Lights that run the height of the panels. The side panel lights
change colors according to the passage mode and reflect the User Status Lights when activated. The light colors and
effects are customized through the SU4500 LED Configuration Utility. Contact Alvarado Technical Support before
changing the LED light settings.
Tools Required
:
•
Laptop with Ethernet port
•
Ethernet patch cable
•
SU4500 LED Configuration Utility
•
SU4500 Turnstile IP address (if changed from the default IP of: 192.168.0.100)
Profiles
:
• Controlled Mode - Requires valid credentials to gain access.
• Free Pass Mode - Credentials not required for access.
• No Pass Mode - Access is not allowed; credential validation disabled.
• Visitor Mode - Bi-directional access allowed without credentials.
• Emergency Override Mode - Upon receipt of a fire alarm, the barriers open towards the exit direction to
permit free egress in an emergency,
• No Barrier Mode - Barrier free operation, valid credentials required to gain access.
• Activate - The turnstile opening upon a successful credential validation.
• Reject - The turnstile remaining locked after a failed credential validation.
• Alarm - The turnstile in an alarm condition.
Each LED group has the capability to change its response during different operation modes through the use of
profiles. The operation mode profiles consist of 3 colors, a transition type, and a transition delay. The profile displayed
is dependent on the turnstile operation mode - for example: while in controlled mode, the controlled profile is
displayed; during an alarm condition, the alarm profile is displayed, etc. Colors are customized using RGB values.
Below are the operation mode profiles within each LED group:
Before Beginning
:
The LED Configuration tool is used to configure the standard set of SU4500 lights, End & Status, as well as the
dynamc light option. When using the LED Configuration tool, you must select whether the turnstile you’re configuring
contains dynamic lights or standard set.
Содержание SU4500
Страница 2: ...This page intentionally left blank...