LEVIGATO DRIVES (LG SERIES)
|
LEVIGATO ANTRIEBE (SERIE LG)
|
COMMANDES LEVIGATO (SERIE LG)
14
GENERAL WARNINGS AND SAfETy RULES
1.3
DURING OPERATION
ATTENTION!
The product should not be used by children or persons with limited physical,
sensory or mental abilities, as well as not trained persons with insufficient experience and
knowledge. Do not let children play with control elements. Remote controls should be located
in the areas, unreachable by children.
Do not touch moving door or moving parts. Before starting the door movement make sure,
that no people, animals, vehicles or objects are in the danger area. Observe the door movement
until it is fully open or closed. It is allowed to pass when the doors are completely stopped and
motionless. The movement of people and vehicles is forbidden when the doors are moving.
It is forbidden to stay under an open doors. The doors with automatic drive can be triggered at
an unexpected moment!
Be careful when using manual release (section 4.2. ‘Manual release’) as the open doors can quickly
fall because of the loosening or breakage of the springs, or unbalance.
Check the drive system and the door design regularly, in particular, check cables, springs and
mounting hardware, for the signs of wear, damage or imbalance. It is prohibited to use the doors
requiring repair or adjustment, as the mounting defect or incorrect balance of doors may result
in injury or product failure. It is necessary to check once a month that when closing in case of
contact of a door leaf with a subject 50 mm high from the earth (floor) the direction of a door
leaf movement changes (for operation of built-in system of protection). Check the operation of
safety devices (photocells, Stop, etc.) on a monthly basis.
Please, follow the safety measures when using the power cable:
• fully insert the plug into the socket; when taking the plug out of the socket do not pull by the cord;
• do not use a socket with bad contacts;
• do not touch a plug with wet hands;
• do not damage the power cable, do not twist the cable, do not bend and do not stretch it;
• do not place heavy objects on the power cable and do not place it near hot objects;
• ensure easy access to the socket;
• use only the power cable supplied by the manufacturer;
• it is forbidden to use a defective or damaged power cable.
In the case of power cable (power cord) damage, it should be replaced by a manufacturer’s
specialist or maintenance department specialist.
When using a curve (filter type) A, the sound pressure level of the drive is ≤ 70 dB (A) at a distance
of 3 meters.
The product is constructed for use in dry buildings and is not intended for use in the presence
of acid, salt or explosion hazard media.
No foreign objects, water or other liquid should be present in the drive or on other exposed
parts. Operation of the equipment in this condition is prohibited.
The influence of environmental factors (direct sunlight, moisture, dust) and construction works
(chips, dust) on the product is not allowed, it can lead to functional malfunctions.
The sources of heat and naked flame must be removed at a sufficient distance from the drive
and its components. The violation of this requirement can result in the damage of the product,
cause it to malfunctioning, cause fire or create other dangerous situations.
It is necessary to maintain regularly the drive system and doors to ensure an efficient and safe
operation. Maintenance and repair must be documented by the persons performing them, and
the owner is obliged to keep these documents.
Do not use the doors if the repair is required!
