Alutech Levigato LG Series, Руководство по сборке и эксплуатации

Страница: 31 / 92

LEVIGATO DRIVES (LG SERIES) | LEVIGATO ANTRIEBE (SERIE LG) | COMMANDES LEVIGATO (SERIE LG)
29
ADjUSTMENT
MENU SETTING
DESCRIPTION
VALUES
DEfAULT
VALUE
P7 f1
Select the operating mode of the photocells
(input ‘ PH1 ’). The input is activated when opening,
or is activated when closing
CL —is activated
when closing /
OP —is activated
when opening
CL.
Y
Connection input ‘
PH1
’ will be active only when closing (
CL
), if automatic closing is enabled
(pause time is set in
P4
-
f1
…
f4
settings)
f3
function ‘ PHOTOTEST ’. The operation of the
photocells is checked before movement by
short-term disconnection and then reconnection
of the power to the photocells transmitter.
Photocells connection diagram— fig. 26
no
—
Off
/
on
—
ON no.
Y
Function ‘ PHOTOTEST ’ cannot be switched off (no) if the automatic closing is enabled (pause
time is set in
P4
-
f1
…
f4
settings)
f4
Select the operating mode of the safety
sensor (input ‘ SE ’). The input is not activated, or
is configured for a resistive sensor (8.2 kOhm),
or is configured for an optoelectronic sensor
(optosensor / OSE)
no
—
Off
/
01 —sensor
8.2 kOhm /
02
—optosensors
no.
f5
Photocells blocking close to the floor level
and the safety sensor (input
‘
SE
’
)
. The setting
specifies the distance from the floor where the
photocells and the safety sensors are ignored
no — Off /
01
,
02
,
03
…
99
99 —maximum
200 mm
no.
P8 f1
The setting of output SL / LL in signal lamp
mode SL : continuous or flashing
no —flashing /
on —continuous
on.
f2
The delay time of the movement beginning
(time of the preliminary activation of the signal
lamp). During the delay time, the signal lamp (
SL
)
works, it signals the beginning of door movement
by a set number of seconds
00 , 01 … 10
00 —0
sec
,
10
—10 secs
00.
f3
Operating time in the illumination lamp ( LL )
mode and the drive illumination after stopping
the door movement
no
/
01
,
02
…
99
no —after the end
of door movement it
is off (0 sec)
01 —5
secs
;
99 —500
secs
(8 min 20 secs )
06.
(30 secs)
f4
The output mode ‘ SL/LL ’: the signal lamp ( SL ) or
the illumination lamp (
LL
).
The signal lamp (
SL
)—works when the door
movement and when the door movement is
delayed ( P8 – f2 time setting).
The illumination lamp ( LL )—works when the door
movement and after stopping the movement
(time setting P8 – f3 )
no —signal
lamp / on —
illumination lamp
no.