Altman AFS-500, Инструкция по установке и эксплуатации

Страница: 6 / 13

Overview
5
AFS-500 LED Follow Spot INSTALLATION INSTRUCTIONS / INSTRUCTIONS D’INSTALLATION
AFS-500 LED Follow Spot Back Panel
Figure 3: AFS-500 LED Follow Spot Back Panel
AFS-500 LED Follow Spot Control Panel
Figure 4: AFS-500 LED Follow Spot Control Panel
ESC ENT. DN UP
DMX512
IN OUT
ON/OFF
AC IN
100-240
VAC
50/60
Hz
FUSE
USE
TYPE
T5AL
250V.
GROUND
WHITE RED GREEN AMBER LT. AMB BLUE
CTO IRIS DIMMER STROBE
LAMP
ON/OFF
DMX Input - 5-pin connector
for DMX512A input signal.
DMX Output - 5-pin connector
for DMX512A output / through
signal.
Power Switch - for turning fixture
on and off.
Fuse Compartment
-
replaceable fuse. Replace
with fuse indicated on fixture.
AC Input - for supplying power
to unit. See
"Power and Data
Connections" on page 6
for
details.
DMX Address (ADR) Screen - for setting
and displaying the DMX address. See
"LCD Display Overview" on page 8
.
DMX Address is set using the buttons on the
back panel.
- ESC (Escape) Button
- Enter Button
- DN (Down) Button
- UP Button
Control Panel - See
"AFS-500
LED Follow Spot Control
Panel"
for details.
WHITE RED GREEN AMBER LT. AMB. BLUE
CTO IRIS DIMMER STROBE
LAMP
ON/OFF
Dimmer Slider - for controlling intensity.
Lamp On/Off - turns
on and off the LED
source only. Note:
does not affect any
other operation of the
fixture.
Color Filter Buttons - for selecting color filters. Note: selecting two
adjacent color selection buttons will result in a split or half-tone color
except for White and Orange. White and Orange cannot produce a
split or half-tone color with each other.
Strobe Slider - for controlling
strobe rate. See
Table 1,
“Strobe Operation (via
control panel),” on page 6
CTO Slider - for controlling color temperature of
the light output. Rotates CTO wheel for 7400K,
6000K, and 4200K.
White Button - White light
output (no color filter).
Iris Slider - for opening and closing fixture’s iris.
Note:
Only control panel shown for clarity.