Altman AFS-500, Инструкция по установке и эксплуатации

Страница: 7 / 13

INSTALLATION INSTRUCTIONS / INSTRUCTIONS D’INSTALLATION AFS-500 LED Follow Spot
6
Power and Data Connections
Table 1: Strobe Operation (via control panel)
POWER AND DATA CONNECTIONS
Power Connection Warnings
Before performing any field wiring, refer to and read the warnings contained in "Important Information" on page 2 .
WARNING! The AFS-500 LED Follow Spot should be connected to a constant circuit or a relay device. It should never be connected
to a dimmer or circuit controlled by a dimmer. Read "Connecting Power" on page 6 carefully on how to properly connect your
fixture.
WARNING! The maximum allowable input current is 20 Amps. Do not overload circuits! Luminaires must be supplied by a branch
circuit protected by a maximum 20 Amp circuit protector. Doit être alimenté par un circuit de dérivation protégé par un maximum de
20 ampères circuit protecteur. Ne surchargez pas les circuits!
WARNING! If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord or cord exclusively
available from the manufacturer or his service agent.
Connecting Power
Units are powered via an AC input cable from 100 to 240VAC, 50/60Hz and draw approximately 490 Watts of power. Table 2 ,
outlines the wire colors and their purpose.
Table 2: AC Input Wiring
Note:
See
Figure 5
for wiring connections.
IMPORTANT!
The AFS-500 LED Follow Spot must be connected to and properly grounded to an viable earth ground.
Figure 5: PowerCON (Blue AC Input) Connector Wiring
Slider Position Strobe Operation
0 to 50% Slower to Fast Strobe
50 to 75% Strobe Pulse Effect (Slower to Faster)
76 to 100% Random Strobe Effect
Wire Color Purpose
Brown
or
Black Main / (L)ine
Blue
or
White (N)eutral
Green/Yellow
or
Green Ground / Earth
Note: The supply cord and connecting
cord should be minimum 14AWG, extra-
hard-usage types such as Type G, S, SE,
SEO, SO, ST, STO, or W.