Altman AFS-500, Инструкция по установке и эксплуатации

Страница: 9 / 13

INSTALLATION INSTRUCTIONS / INSTRUCTIONS D’INSTALLATION AFS-500 LED Follow Spot
8
LCD Display
Controlling with Control Panel
The AFS-500 LED Follow Spot’s functions can be controlled by either DMX or the AFS-500 LED Follow Spot control panel (refer to
"AFS-500 LED Follow Spot Control Panel" on page 5 ).
IMPORTANT! When the AFS-500 LED Follow Spot is connected to a DMX network, the White LED indicator as well as the LED
indicator lamp will flash and the local buttons and fader controls will stop responding until DMX is removed from the fixture.
LCD DISPLAY
LCD Display Overview
The AFS-500 LED Follow Spot has an on-board LCD display. This display is for setting the fixture’s DMX address and displays DMX
information. Refer to "AFS-500 LED Follow Spot Back Panel" on page 5 LCD display location.
There are no other user-selectable settings.
On startup (approximately 60 seconds), the LCD display on the rear of the AFS-500 LED Follow Spot will display the set DMX
address as “AXXX”.
Note: During startup (or calibration period) the AFS-500 LED Follow Spot will make consecutive knocking sounds. These sounds are
normal during the calibration period. Startup is the time frame where power is initially applied to the follow spot and each automated
function is tested through all of its operating sequences.
Setting DMX Address
To set the DMX address:
Step 1. Unit must be powered.
Step 2. Press Enter button on rear of unit. The “A” will change to a “r”.
Step 3. Using the DN (down) and UP buttons, select desired DMX address (setting between 001 - 512).
Step 4. Once DMX address is set, press the ESC (escape) key to confirm setting.
Step 5. LCD display will show DMX address as “AXXX” (address setting between 001 - 512).
IMPORTANT! Note the number of slots that the luminaire is using in order to avoid a DMX address overrun or DMX overlap with
other luminaires in the chain.
5 Strobe
000 Open (no strobe)
001 - 127 Strobe with increasing speed
128 - 159 Pulse - opening - increasing speed
160 - 191 Pulse - closing - increasing speed
192 - 255 Random strobing
6 Reset 128 - 255 Resets fixture to factory settings
Table 4: AFS-500 LED Follow Spot DMX Map
Channel Controls DMX Value Comments