Alpine X009E, Руководство пользователя

Страница: 18 / 212

18
-EN
01GB05X009E.fm
ALPINE X009E 68-24567Z66-A (EN)
Turning the System On
With the Alpine system, when the ignition key is turned to ACC or ON,
the opening screen will be automatically displayed.
1
When the system is used for the first time, the
language selection menu is displayed. There are 24
languages to choose from. Touch
[ ] or [ ] to
scroll the list, and then touch the desired language.
• You can also scroll through lists by touching the screen and
sliding your finger up and down.
2
Touch [OK] .
The radio screen is displayed.
• Some of this unit’s functions cannot be performed while the vehicle is
in motion. Be sure to stop your vehicle in a safe location and apply
the parking brake before attempting these operations.
Inserting/Ejecting a Disc
1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch [ c Disc] .
3
Insert the disc with the label side facing up.
Insert the disc until it is automatically pulled into the unit.
The unit starts to play the disc.
* The SD memory card does not support Music/Video playback.
For details on how to use SD memory cards, refer to “Navigation
system OM”.
• To remove the SD memory card, touch [ SD].
• Insert the SD memory card into the slot until it is locked.
If the SD memory card is not inserted properly, the monitor cannot be
closed.
1
Press
c
(Eject).
The Open/Tilt screen is displayed.
2
Touch
[ c Disc]
.
The monitor will open. Then the disc is ejected.
When the disc has been ejected part way, take it out.
• Even if no disc is inserted, the monitor will open after touching
[ c Disc].
3
Touch
[Close]
, or press any button.
• If the disc does not eject after touching [
c
Disc], press and hold
c
(Eject) for at least 5 seconds.
• Do not apply shock to the monitor when it is open as it may result in
malfunction of the unit.
• The monitor will stop at the set tilt angle when closing.
Adjusting the Screen Viewing Angle
Adjust the screen’s angle for better visibility.
1
Press c (Eject).
The Open/Tilt screen is displayed.
2
Touch
[ U]
or
[ Down]
of “Tilt” to adjust the
desired screen angle.
The screen angle can be adjusted in 5 stages.
3
Touch
[ ]
to return to the normal mode.
• The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle’s battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.
Adjusting the Volume
Adjust the volume by pressing ,
*
1
(or -,+)
*
2
.
Volume decreases/increases continuously by pressing and
holding ,
*
1
(or -,+)
*
2
.
Volume: 0 - 35
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
1
Press MUTE
*
1
(or )
*
2
to activate the MUTE mode.
The audio level will decrease by about 20 dB.
2
Pressing MUTE
*
1
(or )
*
2
again will bring the audio
back to its previous level.
*
1
For Alphard/Vellfire
*
2
For Estima
Inserting the Disc
SD memory
card slot
*
Disc Slot
Removing the Disc
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
monitor tends to become very warm under normal operating
conditions. This is not a malfunction, but care should be taken to
avoid prolonged contact with it.
01GB00X009E.book Page 18 Friday, May 9, 2014 1:16 PM