Alpine X009, Краткое руководство пользователя

Страница: 70 / 250

47
-EN
Setting item: Contrast
Setting content: -15 to +15 (Initial setting: 0)
You can adjust the contrast between LOW (-15) and HIGH (+15).
When it reaches the minimum or maximum point, the display
shows “LOW” or “HIGH” respectively.
Setting item: Sharp
Setting content: -5 to +5 (Initial setting: 0)
Picture quality adjustment range is -5 to +5. “SOFT” and “HARD”
appear as the minimum and maximum values specified.
When adjusting audio (video media), you can store the settings made
for “Adjusting Live Contrast, Brightness, Color, Tint, Contrast and
Sharp”.
Setting item: Preset1 / Preset2
1 After completing “Adjusting Live Contrast, Brightness,
Color, Tint, Contrast and Sharp” (page 46), touch and
hold
[Preset1] or [Preset2] to save the settings.
2 Touch [Preset1] or [Preset2] to call the saved settings.
• Display Mode cannot be registered.
About X009
Touch [About] on the General setup menu in step 3. Refer to “General
Setup Operation” (page 43).
You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support or
an Alpine-authorized dealer.
Setting item: Version Information
Contents: Serial No. / Firmware Version
This unit will display the registration code required to play a DivX
®
VOD (Video On Demand), or you can also display the deregistration
code.
Setting item: Warranty / Copyright Information
Displaying the Registration Code
1
Touch [Warranty/Copyright Information] .
2
Touch [DivX(R) VOD] .
3
Touch [Registration] .
The registration code is displayed on the screen.
4
Touch [OK] .
Displaying the Deregistration Code
1
Touch [Warranty/Copyright Information] .
2
Touch [DivX(R) VOD] .
3
Touch [Deregistration] .
The confirmation dialog screen appears.
4
Touch [OK] .
The deregistration code is displayed on the screen.
• When you have finished, touch [Cancel] . If you want to continue and
display a new registration code, touch [OK] , check the registration
code, and then touch [OK] again.
You can initialize all data, to restore the factory settings. Remove the
CD/DVD disc, etc. from the system before operation
Setting item: Restore Factory Setting
1
Touch [Restore Factory Setting] .
2
After the confirmation message appears, touch
[OK] .
The confirmation screen appears again.
3
Touch [OK] .
The system starts initialization.
• Do not turn on/off the power, change the ignition key position or
remove the screen panel until system restart is completed.
Adjusting Image Contrast
Adjusting Picture Quality
Saving and calling the adjusted picture
quality
Displaying the Product Information
Checking the DivX
®
Registration
Initializing the System