63
-EN
Indication for CD/MP3/WMA
• Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature returns to
within operation range.
- Leave the power OFF until the temperature decreases and
then turn the power ON again.
•
No disc is inserted.
- Insert a disc.
•
Although a disc is inserted, “NO DISC” is displayed and the
unit does not start to play or eject the disc.
- Remove the disc by following these steps:
Press
c
for at least 3 seconds.
• Mechanism error.
1) Press
c
and eject the disc.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press
c
again.
If the error indication still does not turn off after pressing
c
for a few times, consult your Alpine dealer.
• Scratched disc, contaminated disc/poor recording/disc
incompatible with this unit
- Press
c
.
- Change the disc.
HI-TEMP
NO DISC
Error displays
•
Mechanical error
- Press
c
. After the error indication disappears, insert the disc
again. If the above-mentioned solution does not solve the
problem, consult your nearest ALPINE dealer.
MP3/WMA is not played back.
•
Writing error occurred. The CD format is not compatible.
- Make sure the CD has been written in a supported format.
Refer to “About MP3/WMA” (pages 17 and 18), then rewrite
in the format supported by this device.
Unit does not operate.
•
Monitor’s power is not turned on.
- Turn on the monitor’s power.
•
Condensation.
- Wait a while (about 1 hour) for the condensation to dry.
No picture is produced.
•
Monitor’s mode is not switched to the mode you want to see.
- Switch to the mode you want to see.
•
Monitor’s parking brake lead is not connected.
- Connect the monitor’s parking brake lead and set the parking
brake.
(For details, refer to the monitor’s instructions.)
•
Monitor’s parking brake is not set.
- Connect the monitor’s parking brake lead and set the parking
brake.
(For details, refer to the monitor’s instructions.)
Playback does not start.
•
Disc is loaded upside-down.
- Check the disc and load it with the labelled side facing
upward.
•
Disc is dirty.
- Clean the disc.
•
A disc not able to playback with this unit is loaded.
- Check if the disc is able to be played back.
•
Parental lock is set.
- Cancel the parental lock or change the rating level.
Picture is unclear or noisy.
•
Disc is being fast-forwarded or fast-reversed.
- The picture may be slightly disturbed, but this is normal.
•
Vehicle’s battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11
volts with a load applied.)
•
Monitor’s fluorescent tube is worn.
- Replace the monitor’s fluorescent tube.
Image stops sometimes.
•
Disc is scratched.
- Replaced with a non-scratched disc.
DISC ERROR
LOADING ERROR
EJECT ERROR
