30
-EN
Setting the Digital Output
To connect an audio processor using the optical digital output, set to
“ON” by the following procedure.
Setting item: OPTICAL OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The
setting of Digital Output is decided.
Setting the TV Screen Setting
Use the procedure described below to modify the output screen
according to the type of TV monitor (rear monitor) being used.
This setting can also be applied for the IVA-D300R/IVA-D300RB.
If the rear monitor is not connected, the screen setting is 16:9.
Setting item: TV SCREEN
Setting contents: 4:3 LB / 4:3 PS / 16:9
• For some discs, the picture may not be set to the selected screen
size. (For details, refer to the explanation on the disc’s jacket.)
4:3 LETTER BOX:
Select this when connected to a conventional 4:3 size (normal
TV aspect ratio) monitor. There may be black stripes visible at
the top and bottom of the screen (when playing a 16 : 9 size
movie). The width of these stripes will depend upon the
original aspect ratio of the theatrical release of the movie.
4:3 PAN-SCAN:
Select this when connected to a conventional 4:3 size monitor.
The picture will fill the entire TV screen. However, due to the
mismatch in aspect ratio, parts of the movie at the extreme left
and right sides will not be visible (when playing a 16 : 9 size
movie).
16:9 WIDE:
Select this when connected to a wide screen TV. This is the
factory setting.
GENERAL Setup
General Setup Operation
The Parking Brake must be engaged to access the DVD
mode screen. Attempting to access this screen while driving
will display the warning-CAN’T OPERATE WHILE DRIVING.
The following steps 1 to 5 are common operations to each
“Setting item” of GENERAL Setup. Refer to each section for
details.
1
Touch
[SYS.]
on the main source screen.
The SYSTEM selection screen is displayed.
2
Touch
[SETUP]
.
The SETUP screen appears.
3
Touch
[
]
of GENERAL SETUP.
The GENERAL setup screen appears.
4
Touch
[
;
]
or
[
:
]
of the desired item to change its
setting.
Setting items:
CLOCK / CLOCK ADJUST / DAYLIGHT SAVING TIME /
DEMONSTRATION / BEEP / AUTO SCROLL / RDS CLOCK
DISP / FM LEVEL / FM CONDITION / PI SEEK / RDS
REGIONAL / DRC
*
1
/ DAB REGIONAL
*
1
/ AUTO SW DAB
TO RDS
*
1
/ PTY LANGUAGE / PHONE RECEIVE
*
2
/ PLAY
MODE
*
1
Displayed when the DAB Receiver Box is connected. The
DAB operation is stated in pages 53 to 55.
*
2
Displayed only when MobileHub (CXA-B200NK) is
connected.
5
Touch
[RETURN]
to return to the previous screen.
Touch
[MAIN CONT.]
to return to the main source screen
that was displayed before the setup operation was
started.
• Immediately after inputting titles or changing the settings of
General Mode (While the system is inputting the titles or data
automatically) do not turn the ignition key (engine key) to OFF.
Otherwise, the title may not be written, or the settings may not be
changed.
