51
-EN
Navigation System (Optional)
Switching the Navigation Screen (Optional)
If an optional Alpine Navigation System is connected to the IVA-
D300R/IVA-D300RB, the Navigation screen can be displayed on this
unit.
1
Touch
[SRC]
on the main source screen.
The source screen appears on the display.
2
Touch
[NAV]
.
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner’s Manual of
the navigator.
• When
V. SEL
is pressed while the Navigation selection mode is
being selected in “Setting Visual Mode” (page 34), the navigation
mode will be directly activated.
• If the Navigation mode menu is not displayed on the main menu
screen, set NAV. IN to on by following “Setting the navigation
mode” (page 33).
• When the Navigation System is on, the audio and visual navigation
cuts in.
Auxiliary Device (Optional)
Operating Auxiliary Devices (Optional)
To operate your devices connected to the AUX terminals on the rear
panel of IVA-D300R/IVA-D300RB, follow the procedure described
below.
WARNING
It is dangerous for the driver to watch the TV/Video while
driving the vehicle. The driver may be distracted from
looking ahead and an accident could occur.
Install the IVA-D300R/IVA-D300RB correctly so that the
driver cannot watch TV/Video unless the vehicle is
stopped and the emergency brake is applied.
If the IVA-D300R/IVA-D300RB is not installed correctly, the
driver will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could be
severely injured.
• If you try to activate the auxiliary device while driving, the display
will show the warning-PICTURE OFF FOR YOUR SAFETY.
1
Touch
[SRC]
on the main source screen.
The source screen appears on the display.
2
Touch
[AUX]
*
.
The external input screen is displayed.
3
Touch
[NTSC/PAL]
to change the video input.
* AUX-1 to AUX-3 are displayed if the external input devices
(maximal 3) are connected, or the name which is given as the
source name in “Naming External Devices” on page 33 is
displayed.
• If the AUX mode is not displayed on the main menu, set AUX IN to
ON by following “Setting the AUX mode” (page 33).
• The setting of switching NTSC/PAL, which you have set in this
section, can be used in same way in “Switching the Visual Input
Signal” on page 34.
• The display mode changes by touching
[WIDE]
.
For operation, refer to “Switching Display Modes” on page 25.
